Vision MaxPro Przewodnik Instalacji Pobierz pdf (Strona 25)

VR48 Router 25

8.1 Requirements

Electrical Connections

1. A qualified and licensed electrician must be used to complete all wiring and grounding of the

machine according to all state, local, and national electrical codes.

2. Make sure all Junction Boxes and Outlets are mounted according to all state, local and national

electrical codes.

3. Junction Box #1 (50 Amp, 220 VAC, Single Phase) will power the router table, spindle, and controls.

It is typically mounted on Wall A, approximately 36 to 48 inches above the floor surface. The box

should be level with the left edge of the router table. (Refer to Installation Layout Diagrams).

4. Junction Box #2 - for machines equipped with Vacuum Tables ONLY - (40 Amp. 220 VAC, 3

Phase) will power the Vacuum Pump. Mounting should be on Wall A and between 36 inches and 48

inches above the floor surface. If locating the vacuum pump as shown (Refer to Installation Layout

Diagram), locate Junction Box #2 no greater than 4 feet from Junction Box #1.

5. Outlet #1 (20 Amp, 220 VAC, Single Phase) should be mounted on Wall A as shown (Refer to

Installation Layout Diagram - Section 2.1). This can also be another Junction Box if the Dust

Collector is to be direct wired to its electrical source. The dust collector is approximately 2 feet x 3

feet and is on wheels.

6. Outlet #2 (15 Amp, 110 VAC, Single Phase) should have multiple standard three prong sockets for

the computer. It is typically located near the bottom left corner of the router table (home position) as

shown (Refer to Installation Layout Diagram).

7. Wiring needs to be completed to the junction boxes, outlets, etc. before the scheduled first

installation/machine orientation day.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Brak uwag

Vision MaxPro Przewodnik Instalacji Strona 25