Vision VISION-64 Podręcznik Użytkownika Pobierz pdf (Strona 117)

Chapter 4 - The Vision Menus 117

To surface: This value is ignored when using the Vision Serial Controller

or the VE-810 Engraver. The surface is set on the controller and in the VE-

810.

Total depth: This is the total depth that you would like to engrave. This

value is only needed when you are engraving without a nose cone. If you

are using a nose cone, the value should be left at 0.000 because the depth is

controlled by the nose cone.

Z Lift: This value is ignored when using the Vision Serial Controller or the

VE-810 engraver. The Z lift between characters is controlled from the

Vision Serial Controller and from the front panel on the VE-810

Passes: This is how many passes you would like to make to get to the total

depth.

Note: Vision will show you how deep every pass will be.

Cleanup: This is how deep you would like the final pass to be.

Pause before each pass: If this is selected, the engraving table will stop

before it goes to a different depth pass. This would be used if you would

like to change the cutter between passes.

Pause before clean up pass: If this is selected, the engraving table will stop

before it goes to the cleanup pass. This would be used if you would like to

change the cutter before the cleanup pass.

Clear: This will reset all of the parameters in the Pass Depths window to

zero.

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 186 187

Brak uwag

Vision VISION-64 Podręcznik Użytkownika Strona 117