Vision VISION-64 Podręcznik Użytkownika Pobierz pdf (Strona 43)

Chapter 4 - The Vision Menus 43

on Programs, Vision Engraving Software and Edit Material Types. You can

change the Number of material entries to whatever you would like. Then,

you can change the XY Maximum cut speed to a number between 1 and 30

and the Z maximum penetrate speed to a number between 1 and 20. The

higher the number, the faster the maximum speed will be at the engraver.

When you are finished changing the values, go to the File Menu and then

Save. Once the file is changed, you must exit Vision and then enter back

into Vision for the change to take effect. The maximum speed will be

limited to the maximum allowable speed that is set in the Vision Serial

Controller.

Condense Mode: The space bar will toggle through the different

condensing choices. See Condense Mode for more information on this

feature.

Plate Width & Height: You can enter the plate width & height in here.

Plate 1 of 1: This displays the current plate number you are on and how

many plates are in the current job. You can move between plates by

clicking the up or down arrow to the right or by holding down the <shift>

key and pressing <page up> or <page down>.

Line 1 of 1: This displays the current line number you are on and how many

lines are on your plate. You can move between lines by clicking the up or

down arrow to the right or by pressing <page up> or <page down>.

Subline 0 of 0: This displays how many sublines you have on your line of

text and which one you are currently on. You can move between sublines

by clicking the up or down arrow to the right. See Insert Subline for more

information on this feature.

Text: This is where the text for the plate is entered. If you have more than

one line of text, pressing the <enter> key will move you down line by line.

The up and down arrows will also move the cursor up and down line by line.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 186 187

Brak uwag

Vision VISION-64 Podręcznik Użytkownika Strona 43