Vision VISION-64 Podręcznik Użytkownika Pobierz pdf (Strona 133)

Chapter 4 - The Vision Menus 133

X, Y and Z Size: This is the size of your engraving table. This number is

entered in metric which is the calculated by multiplying the table size in

inches by 25.4.

X, Y and Z-Axis Pitch: This defines the pitch of the lead screws on your

engraving table. You should not need to change these parameters.

X, Y and Z Home Offset: This is used to set an offset in the driver from the

upper left corner of the engraving table.

Note: To activate any changes made in this section, you MUST exit Vision

and re-start the program. If this is not done, the changes will not be

activated.

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 186 187

Brak uwag

Vision VISION-64 Podręcznik Użytkownika Strona 133